Exploded view reference:

SORA frame build video here: 
(coming soon)

IMPORTANT:
you must use a set of wire cutters to trim the 4 silicone camera dampers before mounting the camera as shown below:

_{The following setting are specifically for the JHEMCU F745/40A BLheli 32 Flight controller and t-motor 1404 3000kv motors on 6S (Tattu R-line 550mah batteries)}

Setting up the tune:

_{1.  In Betaflight motors tab, Enable BI-Directional dshot (600) and set the motor poles to match the motors you are using.}

 

_{2.  Set the PID values as follows:}

_{3. Set the filter settings as follows:}

 

 

_{4. Set the rates as follows:}

 

 

_{5:  Make sure the ESC's are as follows: (minimum 48khz PMW rate)}